Kbc-networks H.264 Encoder Bedienungsanleitung PDF herunterladen (Seite 10)

Encoder User Manual

Manual-H264_ENC-Rev1207A

www.kbcnetworks.com

2.3 Product Deployment

2.3.1 Product Default Configuration Settings

2.3.1.1 Operations Manual Defaults – Out of the Box Convenience Presets

Prior to shipment from the KBC product warehouse KBC presets configurations for

compatibility with other KBC products, these preset configurations are as follows:

•

LAN/WAN IP Address 192.168.1.100

• LAN/WAN Subnet Mask 255.255.255.0

•

Gateway IP Address 192.168.1.254

•

GUI Access User Account ID admin

•

GUI Access Password admin

• Audio In Disabled

•

Data Protocol Selection (Dip Switch) RS-422/485

•

Video Compression Type MPEG-4

•

Video Streaming Method TCP

• Video Resolution D1, 720 x 480 (NTSC)

•

Frame Rate & Mode 30 FPS, Constant

•

Video Bit Rate & Mode 1.2 Mbps, Constant

• Serial Port Baud Rate 9600 BPS

•

Serial Port Control 8, None, 1

•

Video Control Port 6001

•

Video Streaming Port 6002

Note: If H.264 encoder type is desired, it must be manually configured via the

web browser interface or hard reset to default configurations

2.3.1.2 Factory Defaults

When the reset button on the face of the unit is pressed, or a reset is performed

form the product interface, the parameters of the encoder will become (differences

from manual settings in italics):

•

LAN/WAN IP Address 192.168.0.100

•

LAN/WAN Subnet Mask 255.255.255.0

• Gateway IP Address 192.168.0.254

•

GUI Access User Account ID admin

•

GUI Access Password 123456

•

Audio In Disabled

• Data Protocol Selection (Dip Switch) RS-422/485

•

Video Compression Type H.264

•

Video Streaming Method TCP

• Video Resolution D1, 720 x 480 (NTSC)

•

Frame Rate & Mode 30 FPS, Constant

•

Video Bit Rate & Mode 1.2 Mbps, Constant

•

Serial Port Baud Rate 9600 BPS

• Serial Port Control 8, None, 1

•

Video Control Port 6001

•

Video Streaming Port 6002

2.3.2 Bench Test Set Up

KBC Networks recommends that all equipment be bench tested before being installed

on site. One crossover Ethernet cable is required.

1. Remove the ENC-H-W* Encoder and/or DEC-A (KBC Decoder) from box. The

ENC-H-W* IP address is factory set to 192.168.1.100, the DEC-A IP address is

factory set to 192.168.1.101 unless otherwise noted on provided documentation.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 48 49

Kommentare zu diesen Handbüchern

Keine Kommentare

Kbc-networks H.264 Encoder Bedienungsanleitung Seite 10

Kommentare zu diesen Handbüchern

Verwandte Produkte und Handbücher für Computerzubehör Kbc-networks H.264 Encoder